Main Menu Vehicle Trails Mechanicals TJ/LJ Mods JK Mods Gallery
Door Handle Inserts

Door Handle Inserts

Part #:

I don't normally put things on the Jeep just to add bling without functionallity, but I had seen these on Amazon and decided since I needed just a little more to get free shipping I threw these in the Cart. I didn't expect much since they were so cheap, but I was pleasently surprised when they showed up. Powdercoat was nice and even all around, even inside the holes. The screws were questionable, so I swapped them out for some Stainless steel ones during one of my trips to Lowes's.

Additional Parts:
#8 Stainless Steel Screws 3/4"L

Tools Needed:
Drill
5/32" drill bit
Center Punch
#2 Phillips Screwdriver

 

The parts:
I did replace the screws that came with these just because I wasn't certain of the quality. I quick trip to Lowes picked me up some stainless #8 x 3/4" screws. You will need 10 screws total. As for the ones that came with the handles, I tossed them.
 
Installation:
1. Place and hold the insert in the depression in the door handle. Line it up so it sits flush in the handle.
They don't quite line up perfectly, but it's probably an issue with the amount of powdercoat that is on these.
2. Using the center punch mark a hole for the drill in the center of each screw hole. Remove the insert.
3. Set the depth of your drill to how far the screw sticks out beyond the insert. You don't want to drill out the back side of the door handle.
4. Drill a 5/32" hole about 1/2" deep in the door handle. The end away from the button is hollow. Watch where you are drilling near the button, the handle is angled behind your drill hole.
5. Reinstall the insert and install the screws. Tighten until snug, remember it's just plastic.
6. Done, stand back and marvel at your abilities..

 

 


  N-m Ft. Lbs. In. Lbs.
       
       

This page last updated: 12-May-2017

Content and Design © 2002-present WanderingTrail,  Ronald Seegert
Common Sense and Safety should always be observed when working on your vehicle or doing modifications. Jackstands, wheel blocks, disconnecting the battery are a few of the basic safety precautions that should be used and may not be mentioned in the write ups on this site. You are responsible for your own installation, these write ups are a helpful guideline and should not be taken as an official installation instruction. My write up may be different from the kits currently out there, so alwasy double check the manufacturers installation instructions when installing anything. I try to keep the site up to date with changes that have occured as I discover them, but may not have the latest unless someone lets me know. If you feel that an install is above your capabilities after reading my write ups, I recommend getting together with a club and getting some help. Only a few times have I needed to employe some actual help from a shop to get something done. Usually welding or A/C work. While I have spent many years working on mechanical systems, I am not an expert, nor do I pretend to be one. I hope these write ups have been useful to you.
All trademarked names & logos are property of their respective owners
This site is in no way associated with FCA.
Jeep is a registered trademark of FCA.